Interested to Buy Any Domain ? << Click Here >> for more details...
What are the reasons for AVR failure in LT DGsets ?
- 2 Answers
- 7889 Views
- I also Faced
- E-Mail Answers
Answer Posted / viswanath rao
In lt DG there is no P.F controller. AVR is controlling only
voltage (Automatic voltage regulator)
so in this case AVR get failure.
thanku
| Is This Answer Correct ? | 1 Yes | 7 No |
Post New Answer View All Answers
What is use of starter and choke in tube light
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
what is the function and use of cable differential protection relay?
What is the function of a neutral reactor.
Why we are using Isolation Power Transformer inplace of commercial power transformer? What's the difference between them?
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
can u tell me the promotion from oiller to enginer
How to select the gauge of wire for winding of motors? How to select number of turns for winding of three phase induction motor?
How to do maintenance of transformer feeder.
What is a parabolic signal?
can we make a electric generator,which can not use any type of fuel,air,solar,gas,thermal,coal,petrol,etc and able to produce electrical energy (or self electricity generating generator)
Why it is possible to use PWM with a STATCOM and not with a conventional TCR based SVC
what is transformor oil gread
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
