Explain working of servo controlled voltage stabilizer.
- 3 Answers
- 36535 Views
- I also Faced
- E-Mail Answers
Answer Posted / siddhu
The SERVO CONTROLLED VOLTAGE STABILIZER utilizes a motor
driven variable
auto transformer & a Buck\Boost transformer. Which is
connected between the incoming
phase supply & the load. The primary winding of the Buck \
Boost transformer is
connected to the continuously Variable Auto Transformer in
such a way that One lead of
the winding is connected to a predetermined tap point of
the auto transformer,
depending on the position of the variable brush arm with
respect to the fixed point the
voltage applied to the primary winding has addition or
subtraction on the supply voltage
available on the secondary side.
The autotransformer is driven by an AC synchronous motor to
achieve increase or
decrease in output set voltage by rotating it in clockwise
or anticlockwise direction
depending on the input supply voltage.
An electronic control card continuously monitors the
output voltage and the same is
being compared against the set reference voltage to achieve
the desired output voltage.
The control card responds to the variation in input voltage
in such a way that the motor
in voltage correction doesn’t overshoot in either
direction. This method of correction in
output voltage is free from generating waveform distortion
& harmonics.
| Is This Answer Correct ? | 25 Yes | 4 No |
Post New Answer View All Answers
How does the slip regulator works as a startor
Define conversion efficiency of a power amplifier. What is its value for class c power amplifier?
Which capacitor is preferred for high voltage and frequency?
hi can anyone pls tell me the eee interview core questions asked in l&t
explain PV modules in solar energy generation.
WHat is the general checks required for Dry type transformers
What is cathode ray oscilloscope (cro)?
Why efficiency of generator is higher than motor at a particular load?
why three phase capacitor takes unbalanced current in capacitor bank?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
Is any generator is developed which is operated with out diesal or other expensive source?
Can any answer me ,What will be the range of C.T coil for L&T energy meter EM301 used for 180 kva DG set
why the NGR (neutral grounding resistor) always OFF during DG off?
How can calculate the earthing strip of Copper/GI for rating of 30kV,discharge current 10KA Lightning arrester.
