Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between real and reactive power? and what is the importance of these
- 3 Answers
- 6926 Views
- I also Faced
- E-Mail Answers
Answer Posted / pradhyumn
real power does all the useful work in the circuit, while
reactive power just flows from the source to load and again
from load to source without doing any significant work.
Reactive power in inductive circuits is balanced by
connecting capacitors in series of the circuit.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
main difference between ac and dc?
What are the various types of BUSBAR Schemes? explain each
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
hi plz send me reliance placement papers..i.e electrical technical papers that have been asked in reliance test.
How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?
Lt motor sfu flashing reasons?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating
Draw a block diagramof Three UPS systems connected in Parallel mode?
give me atleast four differences between circuit and network
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
How to check the Bushings of the transformer?
What is the difference between a Root Locus plot and a Bode plot?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
