Interested to Buy Any Domain ? << Click Here >> for more details...
why we use star and delta connection?why we donot give the
supply directly?
- 12 Answers
- 58642 Views
- Hitech, Siemens, Tata Steel Limited, I also Faced
- E-Mail Answers
Answer Posted / hardik
motors basically run becoz of interaction bet'n two flux set
in to stater and rotor. when we give to suppy to fild wdg it
will energies and flux will be proudes and becoz of mutual
induction c/n will produce in rotor wdg and becoz of c/n
flux produce and interact each other and torque will devlop
and motor run as particular direction so its necessary to
produce flux.and flux is devlop by close loop and this type
of connect like star and delta it help to give close loop.
| Is This Answer Correct ? | 5 Yes | 20 No |
Post New Answer View All Answers
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
how works inductive &capacitive sensors?
What is the high series capacitance winding on high voltage power transformer ?
What must be the minimum distance maintained between 2 Generators as per International standards?
we have provided 30 nos. relay contacts in panel.I want to know how do we do the numbering for the relay contacts as per any applicable standards
Define the three phase formula fuse.
I Need standard operation procedure(SOP)for 500kva Oil type transformer oil filtration & Procedure for IR value checking.
what is motor capacity of 80TR chiller? and also say what is the formula related temperature, motor capacity, TR?
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
give some advantages and disadvantages of combiniing the session, presentation, and application layer in the osi model into one single application layer in the internet model
what is the safety of voltage power transformer(2250KVA0
TCS IS IT COMPANY THEN WHY DO THEY NEED ELECTRICAL &ELECTRONICS ENGINEERS?
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to reconfirm its base capacity.
what is level 2 automation?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
