Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between electrical & electronics
- 245 Answers
- 364316 Views
- Axon Constructions, Banking, GDA Technologies, Infosys, MBA, Satyam, Satyam Tech, Snow White, TCS, I also Faced
- E-Mail Answers
Answer Posted / darshak panchal
electrical is a mainly depend on the wire and electronics is
depend on the PCB and IC.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
Why do we use center tap transformer that used with portable tools
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
What is the type of feedback used in an op- amp schmitt trigger?
Which type of transformer is used for lighting loads?
What is the function of attenuator in cro?
The principle of switching circuits for different types of batteries in application of storage systems
draw the full wave and half wave circuit of 3 phase system and inverter circuit used in ups
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
describe the constructional features of an auto transformer and its principle operation
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
