Interested to Buy Any Domain ? << Click Here >> for more details...
what is the most probable reason of failure of current
transformer?
- 2 Answers
- 14782 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / t.gnanavel
if the secondary winding is in open there is no back emf to
the primary winding.so the current in the primary winding
increased to an infinit value and the coil gets burn out.
| Is This Answer Correct ? | 12 Yes | 2 No |
Post New Answer View All Answers
why we used dc supply for field in dg set
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
Explain the fundamental difference between emf (electro motive force) and pd (potential difference) ?
State magnitude criterion.
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
is it true there's a big difference in using Cummins or Denyo...especially power output or leakage
why the rotor current becomes in steady state during high slip region? please verify with equations.
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables
State the methods of improving power factor?
What do you mean by pull of electromagnet?
What is the cut-off rate?
Post possible questions for Power Factor Panel FAT / SAT
