Interested to Buy Any Domain ? << Click Here >> for more details...
What is the use of Isolation Transformer, and Neutral is
using for return path, finally this current is going....
but same time the voltage of the neutral should be below 1
V...
- 6 Answers
- 12610 Views
- I also Faced
- E-Mail Answers
Answer Posted / suppu
isolatin transformer is used for reduse the leakage current
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Why do you have to use Protecion relay with the function MTB ( Mechanical Trip Button ) for electrical system.
How to know about the rating(voltage and other) of induction motor if its name plate is missing at the manufacturing site.
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s
What type of fittings and electrical accessories can be install in radiation area ?
How isolater function when installed inelectrical 440V wiring
dc supply given to dc generator winding.how is possible? my knowledge is saying the winding will burn. please reply.
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
Is there a standard depth of gravel fill in Substation Switchyard? Please give a design/drawing. Thank you.
How to calculat the ratio of HT\LT in energy meter
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
how can i improve the power factor in domestic (230v)
What is the meaning of Insulation H for transformers????
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
How to convert a two phase power into a three phase power in induction machine?
