What is meant by H.R.C fuse?
- 40 Answers
- 181535 Views
- Gas Projects, GSCE, Taj Group, I also Faced
- E-Mail Answers
Answer Posted / shivaraj
high rupturing capacityfuse
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
In HVDC LINE RECTIFIER CONTROL ON CONSTANT CURRENT AND INVERTER CONTROL CONSTANT EXITATION ANGLE CONTROL BUT HOW INVERTER CONTROL CONSTANT CURRENT?
Explain what are inter-poles and why they are required in a dc machine.
State kirchoff current law?
What is the direction of current flow in ct secondary...means if the current is flowing from P1 to P2 then what will be the direction of current flow in ct secondaryw
Why neutral is not used in three phases dol starter
do you have some of interview Questions in power and genrator section in general whith answers
WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.
how do we calculate length of starting time and repeated starting of a direct online starter?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
what are all types of cross section in AC cables?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
how can you size an automatic voltage regulator?
Define damping ratio.
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
HOW WE CHOOSE EARTH'S POTENTIAL AS ZERO V?
