when voltage gets down the current of motor increases. but
according to Ohm's law voltage is directly proportional to
current. plz explain
- 4 Answers
- 7344 Views
- Maruti Suzuki, TATA, I also Faced
- E-Mail Answers
Answer Posted / rohit kumar jha
Two type of emf's are there in motor, first one is due to the
magnetic field set up by the stator and second one is due to
the current flowing in the armature(rotor).
Due to the first emf, a current is set up in the armature,
which is resisted by the current due to the supplied
voltage.As the voltage value decreases the current decreases,
which decreases the resistance to the first current(as both
are opposite in direction), hence the value of current
increases.
It's really a nice and a tricky question :))))
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
I have motor of 3 H.P. How i found the rating of capacitor use in it in single phase motor..???
Draw the equivalent circuit of crystal oscillator?
How to calculate capacitor bank value to maintain unity power factor with some suitable example?
if a number of plc s are there then how many modbus to be used
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
what are pilot cells
Could u pls tell me the NPCIL electrical engineering interview questions for Executive trainee, and also guide me how to face the interview.
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
what purpose to use excaiter in DG.?
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
LT cable fault chaecking equipment and to find out the distance at what distence it failure . Name and where it is available?
Define corner frequency?
what is upper impedance and lower impedance of a distance relay
how many joints are allowed in underground HT cable of 1 KM
Why corona leads to production of Ozone and glow of the color VOILET?
