Answer Posted / bankim sadhu
16-24Hrs
Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
do we consider shrinkage factor for calculating cement consumption for CM mixes for different works?
How you read 5x3x1 #4 @ 20" 0/C in steel structure?
cement and sand required for one block of size 0.23*0.15*0.46
How to avoid fly ash seed ball formations in the concrete mixer while mixing of raw materials for fly ash block manufacturing?
What are the uses of layer?
How good are the Weinerberger Porotherm bricks that are being used in construction in Chennai, India. Its being used in non load bearing walls and has a compressive strength greater that 35 kg/cm^2 and a density of approx.694 - 783 kg/m3.
Does VDF add strength to the flooring apart from preventing water ingress?
what are the types of dimensioning?
what is the 0 value in quantity surveying
What is the ratio of grades m5, m7.5, m10, m15, m20, m25, m30, m35, m40?
The mixture of different ingredients of cement is burnt at?
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
How many % we consider for lap for reinforcement for estimates
How cracks in concrete can be avoided?
i want to ecil (Electronics Corporation of India Limited Hyderabad) previous civil engineering question papers immediately please.............