Interested to Buy Any Domain ? << Click Here >> for more details...
what should be the deduction for bend in stirrups while
calculating cutting length? Is it 1 dia at each bend?
- 6 Answers
- 11836 Views
- I also Faced
- E-Mail Answers
Answer Posted / sameerkhan
There is no deductions of bends its a addition of 1d.
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
What is meant by autocad?
what is kribs is supporting?
What are the uses of alloys in daily life and how are alloys made?
for 32 dia (EQR HYSD steel) bar how much deduction for 45 and 90 degree band
what is the use in canals of longitudinal drains and cross drains in lining areas?
How much cement,sand,bricks and water needed for 1square metre brick work?
List out the potential risk factors for workers on the construction site?
In few lines, please be elaborative on extras and talents that make you a potential candidate for the post:
pile load testing procedure
what is the difference b/w full length and cutting length?
is it fair to recruit another prestressing agency once earlier agency has provided guide cone for post stressing the Concrete -I girders? It is observed that the bearing plate of another agency is not matching with the earlier one resulting in protruded strands after stressing from the face of girder. Kindly advice.
how much tempareture are required to make liquid state of pid leed
how much of the strength comes from post-production curing
What is the use of offset command?
What are advancements in civil engineering?
