Interested to Buy Any Domain ? << Click Here >> for more details...
Hi..i am B.E. (elect.&comm.)..i m workini in a bio mass power plant as inst. Engg. I want 2 know about growth in big power plant sector..is this field is good 4 me ..i m electronics engg..? Plz plz reply..
- 2 Answers
- 5537 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / naveediqbalsher@yahoo.com
According to my thinking it is better field for u.because
power sector have good scope now, also more increase in
future.
i am also working in power field so my thinking like that.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Can combine control system for Emergency control system (ESD)and Fire & Gas System ( F & G) is possble to built and offer to client? Can such system is as per Norms in India?
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
give me all the details about the interview and which type of question being asked
Which products are available in the Mass Systemswitch and System Manager AC range?
what is interlock system and why we use of this?
Explain operation of Haskel pump.
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
Give Detail information about plc,dcs,and scada system?
How d.p. Transmitter can be applied to open tank?
key phaser where is use and work
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
How to Calibrate Vibration Probe (Axial, Redial) in field
What is frequency factor in massflow meter? When using frequency output?
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
