Interested to Buy Any Domain ? << Click Here >> for more details...
How to get Cv of control valve having following parameter
,i.e inlet pressure 4.5kg/cm2
outlet pressure 1 kg/cm2
specific gravity 0.808
- 3 Answers
- 6750 Views
- I also Faced
- E-Mail Answers
Answer Posted / mohammad iftikhar
firstly u need to convert the following parametrs
1- conver inlet pressure into PSIG, your outlet pressure
2- you need to know what is your temperature max & min
3- you must know your flow rate
4- diffrential pressure
5- nominal pize size
6- sizing for ....mean for which fluid
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
Sir,I am going to sit for IOCL written test exam. recently.Can anyone tell me the name of 'Objective type Question Book on Instrumentation Engineering ' which will help me. Pl. mail to bidyut_71@rediffmail.com / bidyut.saha2008@indiatimes.com / bidyut.saha09@yahoo.in
Why boiler chimney area oxyden sensor fixing?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
What is 1:1 redundancy ?
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
Explain the working principle of lvdt?
Why ac supply load cell is used? Can we use the dc supply load cell?
what are the values of fuel flow rate in various places in boiler.
how many types of preheaters are in cement industry & what r they can any body explain?
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
Why mixer nd grinder Is example of constant torque load not variable torque load ???
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
why we use cascade control and feed forward control in 3 element drum level control measurement of steam drum .what is cascade and feed forward control system ?give example .
where cascade loop use ?
