Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / dinesh
two types of transformer's
distribution T/F, power T/F
DRY type T/F, oil TYPE T/F
| Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
What are the effects of adding a zero to a system?
What is the implications when 600 hp motor is started when the unit is running with Transformer of capacity 1500 KVA and DG set of 1000kva
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
How isolater function when installed inelectrical 440V wiring
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
How to calculate per unit impedance of transformer?
how to calculate the conductor size for certain KV transmission line and distribution line?
What safety precaution are to be taken for avoiding electric hazards ?
Lt motor sfu flashing reasons?
How vfd saving power.
What is the effect of pi controller on the system performance?
How can we increase fuel-power ratio of any DG set?
