Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between electrical & electronics
- 245 Answers
- 356497 Views
- Axon Constructions, Banking, GDA Technologies, Infosys, MBA, Satyam, Satyam Tech, Snow White, TCS, I also Faced
- E-Mail Answers
Answer Posted / dinesh mehta
Management of electric power is electrical engineering & Management of electric signal is electronics engineering
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why do power lines not short out when they fall into water?
what happen if the supply is given to the stator of the 3phase induction motor with out assembling the rotor ?
which pump used in WTP explain the function of VFD how to dtermine capacitorbank of capacity one plant
what is the principle of operation of CFL ??
Why power factor should not be in leading (capacitive) mode of any load.
RESPECCTED SIR/MADAM- I AM PRERING FOR SECTION ENGINEER (ELECTRICAL) RRB CHANDIGARH PLEASE SEND ME SOME PREVIOUS YEAR QUESTION PAPER OR MODEL PAPER.MY EXAM IS ON (30- NOVEMBER 2008).I AM VERY THANKFUL TO YOU. FROM- HARENDRA SINGH YADAV
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
What happened when voltage will half value of current ...
why zero sequence impedance measurement is not applicable for single phase GT
Explain how you intend to work under pressure to meet up with deadline target?
why occ characteristics of generator is also called as magnatization characteristics ?
draw 3 phase rectifier diagram
bsnl tta exam question
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
