Interested to Buy Any Domain ? << Click Here >> for more details...
WHICH TYPE OF TRANSFORMER IS USED IN POWER TRANSMISSION
BASED ON TRANSFORMER CONNECTION ON PRIMARY AND SECONDARY SIDE
- 3 Answers
- 5520 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
For voltage ratio less than 3 ,star/star with tertiary is
used and for others delta/star
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How i can calculate current of cable according to ares?
what is the difference between ups & inverter
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
what is the purpose of shading ring or shading coil in electrical equipments.
What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.
How to design pavement quality concrete by using C.R.C.P Method
how a flip flop can be used as a latch?
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
Why in power plant projects we see DOL starting method used for motors upto 160 kW instead of star delta method
For high frequency application we use which transformer?
What are the three major categories of error?
