Interested to Buy Any Domain ? << Click Here >> for more details...
what is the input of digital RPM indicator during the
calibration time?
- 1 Answers
- 4480 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramesh dham
Input for RPM indicator during calibration is signal generator which accurately generate 50% duty cycle square wave having volt. 12 Vdc ( may be adjustable).
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?
What is the difference bitween control net scaner and device net scaner
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
Explain the working of rota meter.
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
Explain types of valves?
Give Detail information about plc,dcs,and scada system?
what is IEC code in cables & how to selecting cables?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
Why mixer nd grinder Is example of constant torque load not variable torque load ???
Draw symbols of the following :
What is the PLC configuration in Cement industry?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
State some of balance principle’ advantages?
State bernoulli’s application.
