1sqm=? wood
- 2 Answers
- 8557 Views
- Ackruti, Nagarjuna Construction, SRS Group, I also Faced
- E-Mail Answers
Answer Posted / m. velmohan
Normally wood qty is taken in Cu.m but some cases such as
door and window shutter are taken in sq.m if it thickness is
specified
| Is This Answer Correct ? | 19 Yes | 3 No |
Post New Answer View All Answers
How to calculate the load of partion in flat slab if we use brick?
How to calculate dry of volume of concrete constant?How it comes 1.54 or 1.57
How to build the floor to ceiling bookcase?
cause of cylinder test failure
why we can use dust in concrete insted of fly ash
What is c.g.i sheet which used for roof??
the water is flowing through a velocity of 1.5m/s in a pipe of length 2500m and dia 500mm. at the end of pipe a valve is provided. find rise in pressure 1. if the valve is closed in 5 seconds. 2. if the valve is closed instantaneously. take value of c = 1460m/s, pipe to be rigid and bulk modulus of water - 19.692x10' n/sqcm
1.Why we are preferring 43 grade cement than 53 grade cement. 2. Approximate cost difference between 43 and 53 grade cement. Thanks.
Pls explain me about tension and compression in a flat slab
In how many types u can do POP on ceiling and walls(on which material or by using which material)? b) what is the difference between dry , oil bound, enamel, acrlyic type of painting? 2nd :- I have certain queries, please help to solve. a) length of pile bore is 4m.excavation quantity will be area * length where area will be pi/4 * dia*dia. Is this right? b) It is a single reamed pile of 300m dia and reamed dia is 750mm. can any body help me to calculate excavated quantity of this bulb(reamed section),, concrete quantity in bulb with showing the formulas to be used?
material used for mendrel use to bend epoxy coated rebar
what is the use of water bar in water tank and is this an extra item in estimate?
how much cement sand n bricks required in im3?and how much in plaster?
how to estimate costing from quantity givin in BOQ and according to this how we fill tender and final rate for perticular work.....?
Why should pumping be not used in case of concreting work?
