Interested to Buy Any Domain ? << Click Here >> for more details...
What will happen if apply dc source for power transformer
- 4 Answers
- 6494 Views
- I also Faced
- E-Mail Answers
Answer Posted / natha
if dc is applied,the nature is non sinusoidal so no flux linkage.this leaves us with simple v= i*r type situation(referring to basic equations).in transformers the winding resistance is low.if 220v dc is applied and resistance of winding is 0.5 then current i=220/.5 which is high value shorting the winding and eventually burning it out.
but why the hell apply dc to transformers in first place
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
do you have some of interview Questions in power and genrator section in general whith answers
Pls Breifly explain about UPS (Inverter,Reserve,Rectifier,Float voltage,Boost voltage).
What is the unit of charge and current?
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
What Is Connection APFC Panel In Compony.
Why does inductive loads consume KVARs?
How CFL &T5 tube light glows?
diff b/w elcb and rccb
What is bode plot?
what are the different methods for the starting of a synchronous motor.
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
Explain about c.t?
What is CCT (Correlated Color Temperature) ?
how point on wave controller works.
