In how we connect watt meter for open & short circuit test
of a single phase transformer.
Answer Posted / k.prakashchandra
connect it in the higher voltage side for SC test and in the
primary for OC test.
Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
Which device of PlC does share load between DG sets when DG are running in perallel?
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
How to calculate VA rating for CT or PT or Control Transformer?
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
What is process of anneling transformer core
Difference between Lugs and Thimbles
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
33kv substation lay out details & line to line & line to earth measurements
how we can calculate power factor in single phase & three phase ?thank u
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
why occ characteristics of generator is also called as magnatization characteristics ?
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
i need the details about bhel exam.how to apply for that.please send to my email-id.thenmozhi2k7@gmail.com