Interested to Buy Any Domain ? << Click Here >> for more details...
Why we use series reactor in power system?
- 9 Answers
- 24065 Views
- Cadbury, HEG, Uttam, I also Faced
- E-Mail Answers
Answer Posted / niaz ahmed bijapure
to limit short circuit current
to reduce 1 2 3 harmonic
to reduce inrush current
to increase inductance , reflectance of circuit
| Is This Answer Correct ? | 26 Yes | 5 No |
Post New Answer View All Answers
what is the max. acceptable leakage current in 33kv bus bar
how hydrogen cooled alternator undergo maintanence ? that is hydrogen when come in contact with air can result into explosions .
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
Is RTCC panel needs any control supply.
what is the path of thunderlightening? once both a buffalo and a person were standing 5m apart but lightening hit and killed buffalo not person?
what is meant by impedance & transient protection?
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
What is limitedly stable system?
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
What is the need of generator relay panel
we specify current in case of feeder but in case of distributor voltage, why?
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
i installed 100kva ups. what KVA genset they should provid in input side? plz any update formula or ans with reason.
