Interested to Buy Any Domain ? << Click Here >> for more details...
WHY WE NOT USE 2-20mA,1-20mA,3-20mA or 10-50mA SIGNAL?
INSTEAD OF 4-20mA.
- 6 Answers
- 13848 Views
- Hindustan Unilever Limited, Yashmun Engineers, I also Faced
- E-Mail Answers
Answer Posted / ravi vaya
Because 4 mA is called live zero of transmeter
If we set 0 mA at 0 pressure ya any ,we can`t deside inst.
is working ok .
And also mA is be a linear from 4 mA
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
What is the purpose of LO Overhead tank in turbines.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
how to convert cubic metre per hour to newton cubic metre per hour
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
May I have a brief note above the voltage barriers? Whats is the purpose? Please mail me if you've operational details, mail id: rajkumar.diice@gmail.com
How to calculate P,I&D value in PID controller ?
what is output of FOUNDATION FIELD BUS transmitter
How does work A temperature valve or fv control valve in process plz brief me
what is function of switch, and how is it work, explain with difination
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
hey any one got the papers of SAIL and HPCL plz do help me by posting them to my mail ID's naren07_87@yaho.co.in, surenarendra@gmail.com
why we r opening HOT BYPASS valve during startup of a compressor?
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
what is basic difference between motion balance and force balance in pneumatic instrument?
