How magnetic balance test of single phase transformer is
done,Especially in ESP transformer rectifier set.
Answer Posted / rajrupa chattopadhyay
Magnetic balance test is performed to detect the inter turn
fault in transformer winding. It mainly focus on induced
balance voltege & magnetising current drawn during the test.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
what is the acceptable limit value for Desolve Gas Analysis/
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
The principle of switching circuits for different types of batteries in application of storage systems
I have 4 DG set with 1500KVA rating. system breakers are 11KV & alternator are 415 Volts. Between alternator & breaker one stepup transformer used. i want to Know what is max. resistance for body earthing & 415 & 11KV V Neuteal earthing. my fault current is 14 times for 2 sec.
How to calculate the fuse rating depend upon the DC circuit?
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
Why we do 2 types of earthing on transformer (ie:)body earthing & neutral earthing , what is function. I am going to install a oo kva transformer & 380 kva dg set what should the earthing value?
Operation carried out in thermal power stations?
What is the current carrying capacity of 0SWG,3SWG,10 & 12 SWG solid bare overhead copper conductors?
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
EXPLAIN WHY THE SURGE CURRENT RATING OF AN MCCB OR CIRCUIT BREAKER DECREASES WITH INCREASE IN THE RATING OF MCCB OR CIRCUIT BREAKER.
what are the industrail measures to over ferranti effect? how would the ferranti effect the power system if those remedial mearsure arent taken? how often does this effect occurs in real power system?
how much flux density of CRNO core