Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / raghavendra
mho relay is admittance relay or it is voltage restrained
overcurrent relay.IT IS USED FOR THE PROTECTION OF LONG
OVERHEAD TRANSMISSION LINE.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Explain The Application Of Storage Batteries?
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
Why we use Electrical energy rather than any other type of energy, mostly? Explain behavior of open secondary CT and short circuited secondary PT in energized condition?
Explain the fundamental difference between emf (electro motive force) and pd (potential difference) ?
WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.
Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?
slipring induction motor starting time Lrs operating why lrs starting time lrs outer body didn't get shock
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
which is the best institute for PLC,SCADA,DCS in hyderabad
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
Thumb rule of cable size(rm>30 rm)X multiplying factor=ampere
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
