Answer Posted / swarnansu
we can get same operating voltage at less cost and when an
3ph short ckt fault occurs it will not increase the fault
since it cant send any energy to the fault point.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain
what are the application of over current relay?
if i get a drop in my 1st year and the i clear my 2nd year and 3rd year all clear and i dont have any back logs so can i be able to sit in campus selection??
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
i have 3500 amp load and select current transformer and perches.how i calculate .please understand
how to find the multiplication factor for digital energy meter and analog energy meter
what is the difference between an alternator and a synchronous motor
what are the applications of TIG welding
Why hydropower stations are preferred solution for meeting peak loads in grids?
If we connect a motor and generator together (I mean that the generator gives the motor electricity and the motor gives the generator movement) regardless the losses. Will the generator still generate and the motor still move?
A cable with concentric PE conductor must be used with frequency converter circuits what does its means.?
what is Fault level? why it is calculated? how will u decide same for our plant?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
What is deference between MCB & MCCB & ISOLATOR
