If I want to lab 16 mm dia. bar with 20 mm dia bar with 40D
lap length which dia.should I consider for lapping
- 12 Answers
- 50633 Views
- I also Faced
- E-Mail Answers
Answer Posted / sudhir patil
As per IS 456-2000 the 50 D of lesser Dia of steel is
considered for lapping.Hence for this case the 16 mm dia
bar is considered therefore the lap length is 800 mm
| Is This Answer Correct ? | 59 Yes | 2 No |
Post New Answer View All Answers
Analyze the rate for 1st class brick work in superstructure with 1:6 cement sand mortar. Consider 1000 cu.ft quantity and work out the rate per cu.ft
What is meant by engineering drawing?
How to calculate the quantity of cement mortar 2" for mosaic tile fixing 12"x12"?
Differentiate first angle & third angle projection?
how much st. steel is required for staging of concourse slab of a elevated metro station allowing through traffic .
What do you meant by gui?
Sir how to find cutting length for footing steel bars in the shape of "u"
what is box type waterproofing and how it is exsiccated and what is the method of doing box type waterproofing
what is cement wastage percentage in NHAI ROAD WORKS
Which is the best book for building construction?
how much shouid be the rate for ready mix concrete per cubic meter
How much cement,sand,bricks and water needed for 1square metre brick work?
how calucate cement sand ratio for plstering
How does a traffic light signal work ?
Explain what is Hybrid Foundation?
