Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.prakashchandra
scott connection
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to know vacuum in vacuum cylinder of breaker in working condition
What is Faraday's law
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
I NEED RRB SYLABUS FOR JE ELECTRICAL ,PLEASE SEND TO MY E- MAIL ID joo28_eee@yahoo.co.in
how much GROUND & NEUTRAL VOLT maintain in data center.
What Is Connection APFC Panel In Compony.
what are the assumptions made in swineburne's test?
Is it advantages of having star-delta vfd than normal star vfd , if yes why?
What is A check, B check, C Check & D check for a diesel Generat
how test transfomer(3 phase75kva) by megger
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
how to maintain frenquncy with syncronising sub-station for distribution
how can we make cable shedule for controll wiring ? which details must be required for it.?
What is the distance between each insulator in 33kv transformer and how can it calculate
