Interested to Buy Any Domain ? << Click Here >> for more details...
1. what is the power factor of a purely inductive load?
2. Which type of transformer connection is preferred in
case of power supply transformers?
3. In power transformer usually which winding is closer to
the core?
4. what will happen to the generated emf if the no. of
poles of an alternator is increased?
- 5 Answers
- 5872 Views
- I also Faced
- E-Mail Answers
Answer Posted / narain
1. For the purely inductive circuit, the power factor is
zero, because true power equals zero. Here, the power
triangle would look like a vertical line, because the
adjacent (true power) side would have zero length.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?
We have a distribution transformer of 750KVA/11kv/440v and an AVR (Servo Stabilizer) of 750KVA on the LT side of distribution transformer. Also we have an ACB of 1200A on the output of distribution transformer (that is on the input of AVR). We want to have an MCCB on the output of AVR. What should be the rating?
After synchronization with grid what is the demand value QKVAR and how we will maintain that?
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
how much winding resistance of 0.75kw to 12.5kw 3ph sqwiralcage induction motor?
How do you select the pickup value of the relay?
How to calculate flow of water delivered by pump when pressure & size of pipe line is given
Can you tell me more about pu systems (per unit systems )calculation in large power systems? how to get the base for voltage and power in generator, transformator and transmission lines?
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
What is gross error?
v/f drive basic princeple
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
Should power factor be low or high?
What is the Resposiblity of Electrical Utility Engineer
