Answer Posted / shadan hashmi
Breakdown voltage is basically a maximum reverse voltage at
which just reaching pn
junction breaks down with sudden rise in reverse current.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
what clearance required for 4.5 mva dry type transformer?
What are the advantages of vscf wind electrical system?
Hello everyone, somebody knows what is a "surplice power" ? The hole phrase is: "This rating is appropriate for a generator set paralleled with an infinite bus e.g. a national electrical supply network or grid where the generator set is run at 100% load, 24 hours a day, 365 days a year and any surplice power is exported into the grid" Thanks in advance.
what is mean by dry frequency
How can we select suitable capacity generator for three phase load (inductive load) and how to take study analysis in 3 three phase load system ?
Mention how NPN and PNP transistor works?
ROC converges if poles and zeros lie inside a. Origion b. Z=1
write down the formula of cable size in RM if current is 50Amp.
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
What is true sine wave or pure sine wave inverter?? Is it sine wave or step wave?? If it is step wave, waves with how much step is considered as pure sine wave? Is it possible to produce pure sinewave using power electronics?
State the other types of Air Conditioners?
Explain the different methods used in the choice of rotor slots for reduction of harmonic torques in an induction motor.