Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / snehchudasama@gmail.com
yes i m agree with this ans that process is fast.but can anyone tell me why process is fast if i increase the derivative gain?or how can system predicted by considering old values?
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
how to tune siemens sipart electro pneumatic positioner..plz tel me..
Difference between dcs and plc including date processing and architecture.
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
What is the constant voltage unit?
How the warning lamp of a charging-system is activated ?
What is the principle of capacitance type level transmitter?
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.
What is the diffrence between digital signal processing and discrete signal processing?
What is the use of double seated valve?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How can measure flow in oil line?which type of transmitter is generally used?
Explain the use of hair spring in the pressure gauge.
How do bending tubing provide better measurement than using tubing fittings such as elbows?
How to erection of DCS Panel at site step by step
