Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nanjilll
Characteristics of control valve:
1. Quick opening => Large change in flow for a small change in Valve travel.(eq. 50% opening gives 90% flow).Usually used as on/off valve
2. Linear => change in flow rate is directly proportional to the change in valve travel(40% flow for 40% valve travel)
3. Equal percentage => not linear but logirthemic variation.
| Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
Any one can help me to identified, how can we interchange the device in FF
How will you test a transistor with a multimeter?
components of control circuit belongs to control valve
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
what is the input to be given in digital flow meter during the the calibration time?
draw the block diagram of a level transmitter ?
Is there any relation between Artificial Intelligence and Instrumentation?
how many type of plug are used in pneumatic control valve,name them.
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
Q- What are the application in which PNP transistor is preferred over NPN ?
What materials are used in thermo wells?
Explain the working principle of lvdt?
How to calibrate level transmitter with use of HART?
