Answer Posted / praveen kumar gupta
If DC is applied to transformer its winding will act as
source of unidirectional flux which causes core saturation
(if DC supply of sufficient magnitude is applied
continuosly).Thee will not be indused EMF in either
winding.Due to this reason transformers are not used in DC
supply .
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
(1)The demand for electricity , the amount of renewable generation available, the amount of fossil fuel generation available and the cost of the fossil fuel generation are shown in table below period(hrs) demand(MW) renewable (MW) fossil- fuel(MW) cost of fossil fuel(MW) 00.00 - 01.00 2000 1800 2000 30 01.00 - 02.00 2300 2500 2000 30 02.00 - 03.00 2500 2700 2100 45 03.00 - 04.00 2900 3100 2100 50 04.00 - 05.00 2700 2600 2500 45 05.00 - 06.00 2400 2000 2700 50 06.00 - 07.00 2200 1800 2000 36 07.00 - 08.00 2100 1600 2000 36 Assuming that the renewable generation incurs zero cost, determine an optimal generation schedule(specifying the amount of renewable generation and fossil fuel generation used in each period, the cost for each period and the overall cost for 8 hours.)
What happen in ups if phase reverse?
What does ampere turns shows?
What are the site acceptance tests for power cables, DG Sets, LT panels & 30kVA UPS ?
what is quality factor in series resonance circuit and calculate the factor of voltage magnification? how it happens?
how works inductive &capacitive sensors?
how to identify the cable quality and what is flame proof cable
What is the difference between Droop vs Isoch Control?
Why Transformer Neutral having one earth pit ( more earth electrode resistance) whereas body have many earth pit ( less earth electrode resistance)?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
Differentiate between ideal and non ideal current sources?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What is effect of over voltage and under voltage on ACB
Can anyone tell the proper diagram of star delta starter????
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
