Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ecxlsync
with regards to their names:
PLC is just a controller and part of the DCS.
DCS is a control system network architecture which has
several PLC's in the field.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What is the use of temprature compensation?
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
what is the process to make control schematic ?
3. Differentiate between ultrasonic flowmeter and radar type flow meter.
How to decrease opening & closing time of on/off valve?
give some question relative instrument fitter?
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
What is zener diode? What is voltage regulator?
how to calibrate load cell
Explain about safety integrated level protection? . How it was differ from other protections ?
hello can yoy pls send me previous papers of jindalpower and steel ltd.....'m from instrumentation..... mani1048@gmail.com
where i can get training in INTOOLS and PDMS in Delhi-NCR OR north part of India. please reply with ur ans. at arunsamkaria@ymail.com
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
