Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ecxlsync
the characteristic of control valve is to open/close partially (by percentage)or fully in corresponds to the command signal from the controller. the open/close action of the CV is linearly proportional to the command signal via a valve positioner (I/P).
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
How to calibrate the flow transmitter
sir, give me placement papers and interview quistion of birla group company of copper.
What is modbus?
how many type conductivity sensor ?
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
what is exact time to study dcs and plc cources
key exchanges in wpa,wpa2,tls
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
What is motion balance principle?
What do you know about gail?
how to work MIL contol valve posistioner ?
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.
