what happens when the profibus fails while in operation
(operation of a valve)?
- 5 Answers
- 13220 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / ecxlsync
in an event of profibus failure or an absence of command signal, some valves will remain its current position, some will return to its safe position (fail safe).
There are valves designed to fully close (Fail to Close) or Fully Open (Fail to Open) in an event of failure.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
use of split range ? where it is used ? in which control loop it is used ?
principle of dead weight tester ?
Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com
hye SAM acn u send your e mail id, so that i can solve my query through e mail?
What is the Working principle of Dozing valve?
can any send me a forbes marshall dtron 316 manual
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Question on maha cement
please send data bank of quetions answers on analytical instrumentation.
this site is owned by an nonsense
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
