Interested to Buy Any Domain ? << Click Here >> for more details...
which gas or which liquid is filled in capillary of dial
type temperature indicators on power transformers
- 2 Answers
- 5224 Views
- I also Faced
- E-Mail Answers
Answer Posted / p.nageswara rao
MERCURY FILLED
| Is This Answer Correct ? | 2 Yes | 11 No |
Post New Answer View All Answers
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
I have completed B.E. Instrumentation & control in 2009. i have 3 year industrial job experience in chemical plant.now, I want to join M.E. in external. so, Plese say easiet way and good institute name.
How to check vortex flow meter is in good condition while we do not having calibration setup?
what is the process for double acting cylinder pneumatic for 32' v/v
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
what is basic difference between motion balance and force balance in pneumatic instrument?
Why do we have earthing cable in branch cable and shield in the same cable?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
what deference between panel earth and systemearth
