Interested to Buy Any Domain ? << Click Here >> for more details...
what is the purpose of checking IR and Megger values in
motor windings?
- 5 Answers
- 9920 Views
- I also Faced
- E-Mail Answers
Answer Posted / srinualn117
purpose of checking IR value is to find,the insulation
resistance between the phases of winding and with
respective to body also.
Minimum IR value required is for 2megaohms/1KV
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Can anyone tell the proper diagram of star delta starter????
Why the efficiency of generator is more than motor in swinburne's test
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
Define reserve-generating capacity?
What is meant by RVT and NDR ? expansion and details of it
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
What is the diff. between single compression and double compression gland
what is laser diodes?
What are the criteria shall be considers for sizing Fuse and MCB? If the rated current is 10Amps what should be the fuse size / MCB Size?
What is the maximum and minimum rating of UPS?
why core is useful for a transformer ?and also in its operation ?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
