what do u mean by 2/3 soleniod valves?
Answer Posted / jagdeep singh
two position and three input outputs. ....or two states
...three ports..
Is This Answer Correct ? | 3 Yes | 9 No |
Post New Answer View All Answers
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
What is the basic difference between Modbus and CAN Open Protocols
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
Decibel.
Exothermic reaction./ endothermic reaction
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
Make Heater Process Logic.
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
Why MUX JB's are using only Temperature Element in Fundation field bus?
what is wave length were using ?
Can anyone send most commonly asked interview question in Oil & Gas industry
If fire would be inside the plant which fire detector is to detected the fire.
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?