Interested to Buy Any Domain ? << Click Here >> for more details...
wat is the difference b/w stress and pressure?
- 11 Answers
- 15791 Views
- IMA, L&T, NTPC, I also Faced
- E-Mail Answers
Answer Posted / bips
stress is the internal resistance offered by a material for
unit area to the externally applied load or force to remain
in its original state whreas the pressure may be defined as
the external load or force applied per unit area which
deforms or tends to deform the material.unit is same coz
both are force in unit area.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Explain the fresh water cooling system.
what's the difference between front and rear wheel drive?on what basis we choose the type of drive?
sir, please send previous years RRB junior engineer (mechanical) exam papers
What minerals are used in the manufacture of cars?
What is viscosity and why is it important?
Maximum combustion temperature in gas turbines is of the order of 1100 to 10°c whereas same is around 00°c in i.c. Engine ? Why ?
sir,i m mech. engg final year student, please send me technical test question with answer for gail,bhel,sail& also useful for other psu exam. thank you....
Action plan to closr NCR (NON COONFORMANCE REPORTS)
why constant pressure is consider for thermal diffusivity??
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What is representative elementary volume?
Define a turboprop engine?
why we open open condenser vacume early when the unit get balck?
Explain nuclear reactor?
increase in unit speed increases the discharge of impulse turbine how?
