Answer Posted / bharani
At least once in two years. Approximately, once in seven
years the PH of the oil is to be tested, and afer fileration
if the PH is found to be around 4, then you have to change
the oil.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why co incidence factor considered in transformer sizing?
how much excitation voltage required to generate 1mw power?
What is the distance between each insulator in 33kv transformer and how can it calculate
Why armature rheostat is kept in maximum position?
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
how to control the speed to switched reluctance motor
how hydrogen cooled alternator undergo maintanence ? that is hydrogen when come in contact with air can result into explosions .
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
what is the principle of operation of CFL ??
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
Define resonant peak?
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
cc of scorpio?
Why we make earth connection with Transformer Body and What will be the minimum size of copper wire as per code with respect to KVA rating of Transformer?
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?