which is heavier 1kg. of iron or 1kg. of cotton?and why?
- 33 Answers
- 99775 Views
- Getco, Jindal, Lloyd, Naval Academy, NDA, samr, swiggy, I also Faced
- E-Mail Answers
Answer Posted / spud667
@Spud666
Its not your club man.If dont know the answer please dont post such vulgar comments.Please dont assume that You only know the bad words.But the problem is this is not the right place.
By the way in respect to your comment I can say "Charity Begins at home"..
bloody modern typical hipocrat with all the F* words always.And the rest of the days are booked for your mother,right?
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
one kg of gas is compressed adiabatically from 1 kg/sq.cm,1 cubic metre volume and 300 kelvin to 5 kg/sq.cm,0.5 cubic metre and 400 kelvin.work transfer in this process will be
Why dtsi is used in motor bikes?
draw p-v dia distingshing naturally aspirated and supercharged engine with reference to pumping loss?
Hello sir, I am Rajaram. I have finished DME (Diploma in Mechanical Engineering). I would like to attend BHEL supervisor examination. So i want which type of questions can i prepare. & give previous supervisor examinations questions. Reply my mail (rajaramsptc@gmail.com)
How cavitation can be eliminated in a pump?
for under water excavation works, can i have some standard codes and specifications(international)
What is the law of thermodynamics?
what is the use of choper motor in pyrometer ?
what are the application or secification (temp/presure)for which IBR pipes should be used?
What are the causes of I.O. high temperature in a diesel engine?
What is volumatric air change of a HOT GAS GENERATOR of a STEAM BOILER ?
what is the required force to bend 2.5 MS sheet in 90 degrees and what is the formula to calculate the same?
I am a post dip. in machine maintenance , 2004 passed out and i am persuing my graduateship in industrial engg. and i would like to know, whether i am applicable to do any certification cource . And i would like to know, whether i am eligiable to do ann master degree since i have working experience of more than 8 Years in Larsen & Toubro,
What will happened if two gear boxes in parallel are working with different motor speeds?
As compression ratio increases, thermal n increases. How is thermal n affected by weak and rich mixture strength ?
