Interested to Buy Any Domain ? << Click Here >> for more details...
how to overhaul control valves.what are the proper procedures.
- 1 Answers
- 19064 Views
- Jindal, QAFCO, I also Faced
- E-Mail Answers
Answer Posted / aftab ahmed mazari
It is a very lengthy topic. I will try to explain some major point.
1. Mark the parts orientation before dismantling, such as mark at body, bonnet, yoke, pressure chambers casing.
2. Note down the threads upper side and lower side of coupling.
3. Suppose, valve is air to open, open it with direct feeding signal to diaphragm upto 5%.
4. remove the coupling.
5. release load pressure
6. Loose yoke nut and remove yoke from bonnet
7. Remove gland packing nuts,remove gland pusher
8. Dismantle bonnet nuts
9. Remove bonnet from body
10. Remove trim material
| Is This Answer Correct ? | 27 Yes | 3 No |
Post New Answer View All Answers
Calibration procedure for electro magnetic flow meter
what is the diffrence between pressure safety valve & pressure relief valve....pls
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
What is the GK Value in Flowmeter?
how many types of spped sensors n vibration sensors?their basic principle n connection?
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
Meaning of the following a. IOP- Manimum; b. IOP- Maximu,;
how u calibrate pneumatic n motorized c/v?
how do u calibrate the vacuum transmitter if it shows more reading
What is the difference between mmwc and mmwg?
What is PDS and PDMS ?
I am using 971 Enraf radar level transmitter for LPG tanks ,the tank side indicator gives the error code 999999999FL can any body give me any diagnostic for this issue?
How the warning lamp of a charging-system is activated ?
types of cable..? Use of every types of cable..?
