Interested to Buy Any Domain ? << Click Here >> for more details...
can a control valve works without positioner?why need
tunning of c/v?
- 4 Answers
- 8338 Views
- I also Faced
- E-Mail Answers
Answer Posted / senthil r.m
my dear,
when there is no positioner it is not called as control valve.i think u dont know about it.we will give 4 to 20 milliamps to the positioner accordin to tht the valve throttles b/w 0 to 100%.Tuning is different concept which i can give u details to go through it.senthilrmohan@gmail.com
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the uses of orifice plates?
How process line mpm calculation is done?
what is function of SCADA , and how is it work, explain with difination
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
Linear amplifier.
Describe the function of Accumulator into the Pump
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
List three types Level Switches with their working principles
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
all types of liquid analyzer principle with drawing?
What is cut off relay? And why use in PLC and DCS?
What is the GK Value in Flowmeter?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
How to convert milliampares into flow??
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
