Answer Posted / soutrick chakraborty

we can control the speed of the dc shunt motor by two
methods. but at first we should know there are two type
speed, 1> base speed 2> top speed. for reach the base speed
we increase the armature voltage maximum , which is
mentioned in motor nameplate. and reach the top speed we
should decrease the feild flux, it means feild current,
which is also mentioned in motor name plate.

Define peak time.

1119

---

1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?

2283

---

11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?

1649

---

how withstand of hi-pot test outputs of transformer wire 2.5mm

1949

---

Zone of protection and tripping scheme of arc protection relay.

1860

---

how to calculate the distance relay faulty zone?pls explain?

2028

---

What is conventional thermal current (Ith)

4420

---

How many points does a Circuit can have?

1942

---

What's mean HVF & HAF in Vacuum Circuit Breaker?

5319

---

In Generator How suction compression power and exhaust works ?

1924

---

specific difference of ICT&Auto Transformer

1869

---

I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience

1624

---

Terminal blocks is used for segregate the connections... There is any principle for terminal block..?

2097

---

What is the main cause of magnetism?

2070

---

is it possible to test of bus bar in high rise building without completed full floor ?

1674

---