in CNC reference how to take? what kind of input give to
the servo amplifier?
- 1 Answers
- 2540 Views
- I also Faced
- E-Mail Answers
Answer Posted / anbarasan
we have to take multi type of input like proximity sensor
and encoder's and resolvers.
Basically use for resolver input. its discreate we
calculate exeact position using poscon controler.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Do you need any help with FEWA Electrical Supervisor exams?
How to calculate approximate load loss of a distribution transformer by knowing %ge imp of transformer?
what are the differant std sizes of cable trenches?
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
Control wiring of a dol starter for forward and backward
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
What cmos is and its benefits?
what is the difference b/w pvc cu conductor and cu breaded wire..?
What is the general system requirement of alternator?
What is the use of bundle conductors?
What are diffrent type of road taxes?
what are all the components required to assemble solar panel other than pv cell?
What is the disadventage of gland earthing(power cable) if any. ?
2. What are the parameters of EHT sub-station?
Phase control and integral control are used for?
