why motor run slow speed in star connection?explain how?
- 3 Answers
- 11584 Views
- I also Faced
- E-Mail Answers
Answer Posted / aditi
In a wye or star connection, the windings of the induction
motor connect from the supply phases to the neutral. In a
delta or mesh connection, the windings connect between the
supply phases.
A wye connection creates higher voltage to the windings of
the three-phase induction motor than a delta connection.
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
can the measured percentage error during calibration of single phase energy meter be negative?
what is the size of cable for 15kw motor and 85 meter cable length using with vfd
What are the types of control system?
what is the electrical?
what is the principle of the single phase energy meter? and,what is the advantages and disadvantages of single phase energy meter?
what is the main difference between power devices and signal devices
How can we convert 11 kv to 440 volt without using transformer ?
What is ferro-resonance in electrical system? Why it occurs and what are measures to prevent it?
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
What is the fault or needs to be done when frequency in ac drives is not changing?
Define Electrical Insulation and examples of Solid,Liquid and Gaseous insulating materials?
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
What is the IS standard for MCCB to be use (As per capacity of AMP)& for ACB also.
how make megger test for control cable like 12c x 1.5mm and what it apply voltage and test timing details.
