Interested to Buy Any Domain ? << Click Here >> for more details...
how to synchronize 4 nos. of diesel generator sets of
different capacity (kva)?
- 7 Answers
- 25669 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / sudhanva madhukar mahamuni
Dear All,
Kindly note that we cant / can synchronise DG sets of
different sizes. There are some major conditions which are
not allow to synch. differrent sizes of dg sets.
assume that 500kVA and 250kVA DG Set we have to syn.
if we loaded 80% on 500kva dg set + 50kva, then 250 will
start up and syn. with 500 kva but kindly note that it will
not share only 50 kva or both will not share the load
equally. and when load will get decrease then due to hunting
effect bigger size will share more load than lower one and
cascade tripping will take place.
| Is This Answer Correct ? | 9 Yes | 7 No |
Post New Answer View All Answers
what is the circutor?why we use it ?
how withstand of hi-pot test outputs of transformer wire 2.5mm
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
How to Decide the Location of Earth pit for Compressor in Oil Depo? and How to measure the resistance of earth pit Pls explain me with the help of Circuit Diagram?
How many size of cable required for a 300m long and 30kw inductive lode
What is effect of over voltage and under voltage on ACB
The size and construction of bushings in a transformer depend upon?
i am completed diploma in ece,and working in ht and lt lines.so is elligible diploma in ece for get electrical C Licence?plse give ur opinion?
how to increase or decrease speed in DC shunt motor by DC convertor
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
Why ground terminal is used in pot meter 10k ohms
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
advantage and disadvantage of team work?
