Answer Posted / md sarfaraz ali

v=m/d=50/2400(density of cement)=.02 cum

In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.

2328

---

16 questions out of 55 were from the book GUPTA N GUPTA OBJECTIVE of civil engineering. Total ques were 4 ques from hydraullics, 7 from BMC, 4 FROM SOM, 4 from soil mechanics, 6 from transportation, 5 from engineering drawing.

18325

---

Could you please give me an answer to the mixing proportion of concrete M1 grade (sterngth of 1 MPa)?

2685

---

what is directivity effect?

2276

---

How to marking the building

1988

---

For the symmetrical continuous beam shown in figure, Prestressed with a force P = 1500 KN along parabolic curve as shown, compute the extreme fiber stresses over the central support for the uniformly distributed load of 24 kn/m. Use load balancing method.

2147

---

Use of coping on terrace wall and in 4" wall is compulsory or not ?

1695

---

How can we calculate 8- storied Madrasha Building pile capacity by taking SPT value at site?

2160

---

what is the coefficient for running feet to cft coversion both area and price

2440

---

How to calculate plastering for elevated water storage tank

1332

---

give me the rate analysis for Bituminous Macadam and SDBC

7485

---

How to construct a water sump in a rocky soil?

2279

---

how to calculate weight of 1.8 cum of aggregate

1773

---

1. What is coefficient use for calculation of shuttering. 2. What is coefficient use for calculation of reinforcement in one cum of concrete.

8196

---

what is the difference between tsp & tower

2537

---