single phase can run in PVC conduit. Three phase can also
run in one PVC conduit. But two phase cannot run in one PVC
conduit. WHY? reply plz....awaiting your answer.
Answer Posted / k.prakashchandra
Because we have only single and three phase circuits or
systems and not two phase.
| Is This Answer Correct ? | 1 Yes | 13 No |
Post New Answer View All Answers
why would amp draw on neutral wire be as much as amp draw on the hot leg.
I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
what are the tests comes under the type test, what tests comes under routine tests.
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
what is the function of capacitor duty contactor in an capacitor panel???
Differentiate between kirchhoff’s first law and kirchhoff’s second law?
static chagre
What are the advantages of nichols chart?
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
what is the need to express current and voltage in rms value? rms value is also called as effective value,what is effective value?
Difference between On Line capacitor and Station Type capacitor.
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
There is any especial requirement for motor to drive through with VFD?
Draw the single line diagram of the power station?
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH