Interested to Buy Any Domain ? << Click Here >> for more details...
The speed of a dc motor can be controlled by the variation of
1. armature voltage. 2. field current. 3. armature circuit
resistance. 4. angle of brush shift.
Which of the statements given above are correct?
(a) 1,2 and 3 (b) 2,3 and 4
(c) 1,3 and 4 (d) 1,2 and 4
- 1 Answers
- 3532 Views
- I also Faced
- E-Mail Answers
Answer Posted / nawal kishor
(a) 1,2 and 3
| Is This Answer Correct ? | 16 Yes | 0 No |
Post New Answer View All Answers
How can ou verify the size of conductor 50Sq.mm ACSR
if a.c supply is given to the motor,, what happen?
Why an ac systems are preferred over dc systems?
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
HOW MANY TYPES OF FUSE?
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
if we have 320KVA Genset kindly advice how much load we can put it.
where can the transformer having vector group Yny0 be used??
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
State kirchoff voltage law?
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
What are the conditions for sustained oscillator or what is backhouse criterion?
Can anyone explain me about the capacitor calculation
can any one provide me a connection wiring diagram for a DG set control panel along with BOM?
